pro vìtí obrázek.
||Double-Wall Tanks, Containment Sumps, and Double-Wall Pipes Applications
||Three Distinct Outputs: Dry, Water Present, Fuel Present
||Compact Fits Interstitial Spaces
||Unaffected by Vapors; Even at High Concentrations
||Easy Removal and Re-installation for Cleaning
||No Moving Parts Long Life
Proven electro-optic and conductive technologies are combined to deliver advanced capabilities in the LV132 discriminating liquid sensor.
Internal logic discriminates between water- and hydrocarbon-based liquids. No moving parts and solid-state switching encased in a rugged housing
ensure dependable, long service.
A slim, compact form allows easy installation into interstitial areas of double-wall pipes and tanks using an integral pull ring to snake into place.
Remove the pull ring and the LV132 installs into any tank or reservoir via 1/4 FNPT fittings for high, low, or intermediate level detection.
The LV132 sensor is easy to remove, clean, and reinstall after an alarm condition is triggered, or for maintenance.
The LV132 electro-optical/ conductivity sensor contains an infrared LED and a light receiver. Continuous light from the
LED is directed into a prism which forms the tip of the sensor. Two probes extend from the prism to measure conductivity.
With no liquid present, light from the LED is reflected within the prism to the receiver. When rising liquid immerses the prism, the light is refracted
out into the liquid, leaving little or no light to reach the receiver.
Simultaneously, the conductivity probes determine if the liquid is conductive (water-based) or non-conductive (hydrocarbon-based).
Sensing the change in light intensity and measuring the liquids conductivity level, the receiver actuates electronic switching within the unit.
A logic circuit built into the sensor housing evaluates the two inputs and gives one of three output signals: Dry, Water Present, or Hydrocarbon
Wetted Materials: Polysulfone, PVC, 316 Stainless Steel, Epoxy, Nylon
Operating Temperature: -17.8 to 80°C (0 to 176°F)
Maximum Pressure:50 PSIG
Current Consumption: 18 mA,
Output: TTL/CMOS Compatible. May sink up to 40 mA, up to 30VDC.
Cable: Four (4) Conductor PVC Jacketed
(25 ft Extended)
Approvals: UL Classified for Class I, Group D Hazardous Locations
Weight: 340 g (0.75 lb)
Not recommended for use in any liquid that crystallizes or leaves a solid residue.